Step | | Procedure & Parts & Tools |
1 |
|
Drop squeegee and check over the slide bearing. If there is excessive play/wobble or if the black plastic is cracked. It will need replaced. Remove the 4 13mm bolts around the bearing.
Ratchet-Deep socket metric 13mm |
|
|
2 |
|
Remove the whole squeegee mechanism out as a unit.
|
3 |
|
Remove the 10mm bolt in the rear to release the tension on the coil spring.
Ratchet-Socket metric 10mm |
|
|
4 |
|
When the bolt is out, slide the arm forward and remove the coil spring.
|
5 |
|
Using flathead, remove the large axle by popping off a clip. Replace if either looks worn/damaged.
|
6 |
|
The smaller axles are also held in by clips at the spring cups. Remove the clips to the spring cup in the middle of the arm assembly.
Screwdriver-flat tip |
|
|
7 |
|
Remove the smaller axle and spring cup. Replace axle if wear is seen
|
8 |
|
Arm assembly can now be separated. Replace if bent.
|
9 |
|
Unbolt the three 17mm bolts to remove inner bracket from Slide Bearing
Ratchet-Socket metric 17mm |
|
|
10 |
|
Reverse steps to assemble and reinstall the mechanism as a unit.
|